Summer, heat, everyone refreshes as they can. For some, this is a split system or mobile air conditioning, for some, life without a “central climate” is not sweet, and someone just sleeps in the bathroom, covered with a wet sheet. But another simple way to alleviate some of the suffering is a fan, which, although it blows the same hot air, helps to survive the heat. The STARWIND SAF1251 floor fan is one such assistant.

Contents

  • specs
  • Packaging, appearance and equipment.
  • Exploitation
  • Leave

specs

Model

STAR WIND SAF1251

Kind of

Floor fan

Energy

50W

number of blades

5 pieces

Number of operating modes

3

Peculiarities

Tilt adjustment, automatic rotation, work timer (from 10 minutes to 1 hour)

Control type

Mechanic

Power cord length

1.7 meters

Dimensions

1300*430*430mm

Packaging, appearance and equipment.

The device is in a square but flat box, designed in a corporate style.

It has all the necessary information about what the fan can do, features, as well as the appearance of the device. Inside, all the components are in their packaging, and the part with the motor is protected by a cardboard insert.

First we find the protective casing removed from the impeller. These are the two classic bowls made of metal wire rod that will protect the impeller from damage and vice versa, protect everyone, which is important for children. The impeller with a diameter of 34 cm and 5 narrow blades is made of transparent, darkened plastic. Fasten the two halves of the carcass of the lunges with honor in a plastic clamp, somewhat reminiscent of a similar one for barrels.

The base is extremely heavy, made of plastic, reminiscent of a well hatch. A decorative layer of plastic is laid on top, as a result of which the heavy support acquires an attractive appearance.

The holder is made of metal and has a clip closure that holds the inside. If necessary, it can be extended, that is, telescopic support. It is fixed to the post with an L-shaped screw with a wide washer. It is much more difficult to start than with plastic parts.

The control unit with the motor is typical in appearance. It has a “mushroom” to activate the automatic turn to the left and right, and it also has a swingarm in manual mode. Untypical for a fan, there is a run timer that allows it to work from 10 minutes to an hour, or be on constantly. In addition, there are 3 standard speeds and a zero position.

STARWIND instructions are always concise, concise and without water.

Exploitation

It’s time to cool off. A scattering of parts is fine, but it would be necessary to bring all this together in a single structure. First we will mount the support and install the rack.

The two halves of the bracket simply snap into each other. We insert the rack with moderate force into the hole and fix it with an L-shaped screw with a washer.

We install the control unit on the rack, after loosening the tightening screw. After successful installation, please tighten it. Here too – metal-metal, which will definitely affect durability.

We install the back of the casing, which we attract with a plastic nut. Then we install the impeller in its place, matching the grooves with the bosses on the shaft. It is also attracted by a left-hand threaded nut, which usually prevents it from unscrewing during operation. And then you need to install the second part of the casing and tighten them with a clamp. I advise you to immediately tighten it a little so that it is back to back and attach it to either half of the protective casing. Then, after the end of that process, we tilt the second part and, as if we were fitting it into a clamp, we install it in place, tightening the screw after that. If you try to attach the two halves together and secure them with a clamp without this preparation, then if you are alone you will most likely fail. Components keep popping up. In any case, “youth won!” ©.

The fan is ready to work.

The fan is controlled simply: first we turn on the ON position on the block with the timer, and then turn on the desired speed with the usual buttons. If you need to work in the interval of up to one hour, set the position not to ON, but to the desired number. In any position, including ON, the timer block emits a slight ticking/cracking noise, which almost all of these timers do (for example, in an oven).

The fan generates quite a strong airflow even at the first speed, the noise is also loud if it is close. At the third speed, the flow is strong and sufficient for a distance of 5-6 meters. Those. the fan copes with its task – it blows to be healthy. It lacks a carrying handle, which is often placed on the motor housing. Now some measurements, let’s start with the simple ones.

The photo shows two extreme positions for adjusting the height of the fan. The height from the ground to the edge of the carcass varies from 111 cm to 128 cm, in combination with the tilt of the head to both sides, this range is quite enough.

The noise at a distance of 1 meter is noticeable even at the first speed, not to mention 2 and 3. There is not enough lower speed, ie the fan blows too much, but this can be greatly smoothed out by simply moving it away from you. Looks like you have some stock. by flow force

Consumption at maximum speed is set at about 50 W, at least 40.2. If you turn on the twists then 0.4W will be added (last photo).

Let’s take a look at the engine.

I didn’t find any brand.

To buy

Leave

STARWIND SAF1251 – with its low price and good features, it can be an excellent option to overcome the period of unbearable heat. Perhaps for someone the timer mode will be useful, which can be set to work up to an hour, for example, at the time of falling asleep.

Summer, heat, everyone refreshes as they can. For some, this is a split system or mobile air conditioning, for some, life without a “central climate” is not pleasant, and someone just sleeps in the bathroom, …

Have you ever wondered if a refrigerator can cool down a room? They usually say no, but I’ll say it’s possible. But all is not so simple. First you need to understand how a refrigerator works.

Today’s review will focus on the intelligent Hiper Pet Feede LE automatic feeder, which will allow you to leave your pet alone for a long time. With a mobile app…

The house is located on Mosfilmovskaya street in Moscow. It was built in 2014 and belongs to the Michurinsky residential complex. I tried to take a picture of the whole house, but even from across the street…

Amazon tablets are simple but high-quality devices for consuming multimedia content, characterized by incredible survivability and even indestructibility. They are like workhorses every day…

DEEPCOOL literally upgraded its liquid cooling lineup and received the LS label. In this review, the LS520 model. Of the key changes, we can note an interesting pump and…

Source: IXBT

Previous articleStranger Things nomination for Outstanding Drama Series at the 2022 Emmys is absurd
Next articleAmazon Prime Day 2022 portable air conditioners for sale

LEAVE A REPLY

Please enter your comment!
Please enter your name here