Can be while listening to music with headphones Xiaomi and from time to time, you will hear a disturbing sound. crunch this will cause you to stop enjoying the song in question. You’re not the only person this has happened to, and luckily, there is a way to fix them without having to return them.
The reason the above happens is because the codec is used. CCA and apparently quite a few users are reporting issues with it. As is already known, no worse quality than using SBC. What happens is that a squeaky sound that can reach is randomly reproduced. bother when wearing headphones (especially if they contain noise canceling).
Pretty simple way to prevent this from happening
Well, there’s a lot of folks running around to get avoid what we’re talking about is that the AAC codec we’re talking about is pretty common these days (especially if you’re using an Apple iPhone where it’s basically king). Attempts have been made to fix this in several ways: disabling Dolby from terminals and even removing sync options from the developer options of devices that allow it… And none of this has been effective.
Fortunately, the key was finally found so that the annoying squeak we were talking about stopped occurring when the AAC standard is used with any Xiaomi device. And it’s much simpler than it sounds: all you have to do is access the Bluetooth or Audio options of the terminal you are using and find the part that allows it there. enable this A2DP technology to be operational. This is usually indicated by a slider, so you have to use it until it’s clear, not gray.
This is surprisingly failures what did we discuss To get lost totally… and the truth is, there’s no specific explanation for it. Apparently this allows you to optimize the behavior of the AAC codec so that it runs smoothly.
Will there be a solution to this problem?
It is hoped that this is the case and it ends up in one of the Xiaomi launch locations. updates a change that fixed what happened to some users. It would be ideal. It is true that the standard we are talking about is not the most used standard (with the exception of Apple), but it is ok if a new firmware comes with the corresponding solution to avoid disappointments.
Source: Cincodias Elpais
